Changing the Operating State

Change the operating state of the instrument at the electronic ON/OFF Switch as follows:

1

Get the ParaVision workplace ready of use and start ParaVision.

2

Switch System ON:

  • Turn the rotary switch (1) clockwise in ON position.
  • Press the ON button (3) briefly and wait until the signal light lights up green permanently.
    • The instrument is now ready for use.

3

Switch System to STAND-BY:

  • Press the STAND-BY button (2) briefly and wait until the signal light at the ON button (3) changes from green to orange.
    • The instrument is deactivated and not ready for use (stand-by).

Note: You only need to press the ON button (3) briefly again to switch back to the operating state »System ON«.

4

Switch System OFF:

Turn the rotary switch (1) counter-clockwise in OFF position.

 

 

You can switch interactively between the operating states STAND-BY and ON using the ParaVision software. Proceed as follows:

  1. Click the ON/OFF button (1) in the ParaVision control bar to switch between STAND-BY and the operating state ON.
ON/OFF button in the ParaVision control bar.